![]() ![]() INPUT Jack – This ¼” jack is the audio input for the Nano Looper 360. If the loop has recorded memory, the MEM LED remains on and playback can begin. If the loop has no recorded memory, the MEM LED remains off. When scrolling through loops, the MEM LED flashes quickly during transitions. The dry signal also remains analog throughout the 360. Your dry signal remains at unity signal level from input to output. LEVEL Knob – Controls the output level of the Loop. Optionally may use 9V Alkaline Battery, battery life: approximately 4 hours of operation (varies on conditions of use) High quality, uncompressed audio: 24-bit A/D/A, 44.1kHz Sample Rate 11 selectable, independent Loops, that remain in memory until you erase them Using the wrong adapter or plug polarity may damage your unit and void the warranty. The Nano Looper 360 requires 90mA at 9VDC with a center negative plug. WARNING: Your Nano Looper 360 comes equipped with an Electro-Harmonix 9.6DC200BI power supply (same as used by Boss ® & Ibanez ®: 9.6 Volts DC 200mA). Not only that, the available 360 seconds can be divided into 11 different Loops, so you get the most out of the available memory! You can think of the Nano Looper 360 as your very own “Loop Locker.” Congratulations on your purchase of the Nano Looper 360! The Nano Looper 360 is a small, extremely easy to use looper with a total of 360-seconds of loop recording time. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |